Damp Guard and Thinner

Scope:

Berger Damp Guard is a high quality and quick drying product having water resistant properties. It is lead free product which is recommended to apply on cement and plaster surfaces. It can be used for both interior and exterior surfaces.

Uses:

Berger Damp Guard is especially designed to protect cement and plaster surfaces. Berger Damp Guard prevents moisture penetrating into the surfaces and increases durability of the concrete surfaces. The product is suitable to prevent flaking of painted surfaces.

Surface Prepapation:

All surfaces should be clean, free from dust, dirt and efflorescent salts. Scrap off all nibs and loosely adhered plaster or cement from the surface and then sand the surface thoroughly. It should be ensured that the surface is completely dry.

Application Procedure:

Apply 2 coats of Berger Damp Guard along the Berger Damp Guard Thinner for thinning and let it dry. Allow the surface to dry for 2 to 3 hours between coats. After complete drying use sand paper to remove all extra material from the surface dust out the whole surface. Apply suitable primer/putty/painting system as per requirement.

Application with brush or roller: Thinning ration will be 10-15% approximately by volume with Berger Damp Guard Thinner.

Application with spray gun: Thinning ration will be 20% approximately by volume with Berger Damp Guard Thinner.

Drying Time:

Berger Damp Guard dries within 2 to 3 hours depending upon the ambient temperature. Allow 2 hours for drying between the coats.

Coverage:

It covers 12-13 meter square per liter coat; depending upon porosity of surface.

Packaging:

It is available in 3.64 litre pack size.

Safety Precautions:

The container should be protected from extreme hot and cold temperature. It should be properly closed and kept in upright position after use.

Dump Guard Thinner Scope:

Berger Damp Guard Thinner is recommended to thin Berger Damp Guard for easy application.

Uses:

Berger Damp Guard Thinner is especially designed for thinning Berger Damp Guard and Application equipment cleaning.

Application Procedure:

Application with Brush or Roller: For Berger Damp Guard thinning ratio will be 10-15% approximately by volume with Berger Damp Guard Thinner.

Application with Spray Gun: For Berger Damp Guard thinning ratio will be 20% approximately by volume with Berger Damp Guard Thinner.

Colour:

Water whiter.

Safety Precautions:

– Use goggles and gloves while handling.
– Avoid direct contact with skin. In case of direct contact with skin or eye, clean with fresh water.
– Don’t inhale for long time.