Wall PUTTY

Scope

Berger Wall Putty is a ready-to-use high quality putty for interior use only. It forms the ideal base to give a smooth finish for water-based paints. It should not be used on exterior surfaces.

Uses

Ready-to-use Berger Wall Putty is highly recommended where smooth performance is required. Berger Wall Putty is designed for use on cement surfaces, concrete, chipboard, plywood, etc.

Note: It is recommended that Berger Wall Putty should be coated with a thin coat of Berger Plastron Primer if the subsequent finish to be applied is VIP Super Gloss Enamel or Allrounder Matt Enamel.

Surface Prepapation

It is extremely essential to completely dry and free the surface from grease, dirt and dust by using sandpaper or scrapers before applying Berger Wall Putty.

Note: It is recommended that on previously painted surfaces, scrape to remove all old paint which is lose and flaking and apply a thin coat of Berger Plastron Primer before applying Beger Wall Putty for a better finish.

Drying Time

Berger Wall Putty under normal conditions surface dries within 2 hours and is ready for over-coating with finishing paint after 16 hours.

Coverage

Berger Wall Putty covers 5-7m2 per kg per coat.

Packaging

Berger Wall Putty is available in 6 kg and 20 kg packs.

Safety Precautions

The container should be protected from extreme hot and cold temperatures. It should be properly closed and kept in an upright position after use.