Call Us: 111 237 437 | For Free Color Advisory : 08000-2000 | info@berger.com.pk

  • Home
  • About Us
  • E H S
  • News and Events
  • Careers
  • Order Now

Scope

Berger NU PrimeSeal is formulated to resist alkali and moisture present in the new plaster surfaces. It forms a tough and flexible film which prevents passage of moisture from the substrate through the paint film. Before the application of Berger NU prime seal, it is essential that the surface to be painted should be dry and free from grease and dust. It is for interior use only.

Uses

NU PrimeSeal has been designed for use on cement render concrete, lime plaster, asbestos cement sheets and all other surfaces which require sealing against moisture or alkaline substrate.

Surface Preparation

NU PrimeSeal can be applied by thinning (1:1) with water by volume for brush application (depend on surface absorbency). For better results apply two coats of NU PrimeSeal. For previously painted old surfaces, remove all defective or poorly adhering material by rubbing with a suitable abrasive paper or stiff brush. To smoothen the surface, Berger Wall Putty can be applied after the application of NU PrimeSeal.

Application Procedure

NU PrimeSeal can be applied with brush, roller or spray. To obtain a desired viscosity for brush application, thin with 12-15% of good quality turpentine and up to 20% for spray application.

Drying Time

NU PrimeSeal dries within an hour and can be recoated after 2-3 hours.

Coverage

NU PrimeSeal dries within an hour and can be recoated after 2-3 hours.

Packaging

NU PrimeSeal is available in 3.64 and 14.56 litres pack size.

Safety Precaution

The container should be protected from extreme hot or cold temperature. It should be properly closed and kept in an upright position after use. In case of contact with eyes rinse with water and seek medical advice.